proconX: Protocol Converter & Gateways

Serial Device Server
Smart Industrial Communication and Embeddeded Ethernet Solutions
 Login 
Overview
Power Industry
Serial Device Server
Serial to Ethernet SERIP-100
Modbus Gateway MODG-100
Programmable Gateways
Ethernet CPU Boards
Shop
Information and Support
We accept VISA, MasterCard, PayPal

World Wide Shipping

Serial to Ethernet Converter and Gateway

The SERIP-100 is proconX' low-cost Industrial device server offering one or two software selectable RS-232/422/485 serial ports and a 10 Mbit Ethernet port.

The SERIP-100 acts as an interface converter and connects a serial device to Ethernet. It support a variety of different operating modes and can act as client and server.

With it's DIN-rail enclosure and 10-30 V DC power supply it is easy to install in automation panels and switchboards. Cables are fed in from top and bottom and makes wiring of the communication ports easy.

The unit's firmware adheres to the Internet Standards (RFCs) as close a possible. This provides it with a high degree of compatibility with a broad range of available commercial and open source middleware, drivers and utilities.

Keeping in line with the proconX Range of products, the SERIP-100 features Web Page configuration and firmware upgrade over the network.

SERIP-100 Device Server Key Features Features SERIP-100 Device Server Key Features SERIP-100 Device Server Brief Description Brief Description SERIP-100 Device Server Brief Description SERIP-100 Device Server Specifications Specifications SERIP-100 Device Server Specifications
 

Specifications

Protocol Conversion Engine

  • Server Mode
  • Client Mode
  • UDP Tunnel Mode
  • Compliant with Telnet Standards RFC 854, RFC 855 as well as Telnet COM Port Control Standard RFC 2217

HTTP Server

  • Provides status and diagnostic information
  • Allows device commissioning and configuration
  • HTTP 1.0 compliant

TCP/IP Stack

  • ARP, ICMP, IP, TCP, UDP, FTP, DHCP, Telnet, HTTP protocols

Serial Port

  • Software configurable as:
    • EIA-232-F port with RD, TD, RTS, CTS, DCD, RI signals
    • EIA-485-A port with A-,B+ signals
    • EIA-422 port with RD+, RD-, TD+, TD- signals
  • 300 bps to 115200 bps baud rates
  • 5, 6, 7 or 8 data bits, 1 or 2 stop bits, no, even or odd parity bit

Ethernet Port

  • Half-duplex IEEE 802.3i 10BASE-T compliant Ethernet port w/ RJ-45 socket

Main Board

  • Watchdog timer for high availability
  • Brownout detection

Protection

  • 10 kV ESD protection on RS-232/RS-485/422 ports
  • 1.5 kV galv. isolation on Ethernet

Power Requirements

  • 10-30 V DC, 750 mW
  • 30 mA typical @ 24 V DC

Environment

  • 0° to 60° C operating temperature
  • -25° to 85° C storage temperature
  • 10 to 95% humidity, non-condensing

Form Factor / Enclosure

  • 35 mm DIN Rail mountable PC/ABS enclosure
  • IP 20 / NEMA 1 protection rating
  • 101 x 22.5 x 120 mm w/ enclosure
  • 0.12 kg (0.265 lbs)